About This

• 【Wide Compatible】Bamboo Lab high flow hotend for H2 series - H2D,H2S,H2C Left,P2S, X2D, with 0.8mm hardened steel nozzle. Please Note: H2D high flow hot end is compatible with A1 Series, but it will not improve volumetric speed. In other words, the high flow hot end performs the same as a standard nozzle on the A1 Series.
• 【Real High Flow: Save Up to 30% of Your Time】The h2 series high flow nozzle's optimized melt zone enables significantly increased volumetric speed, achieving up to 62.5% higher max volumetric speed and reducing print time by up to 30% with ease. The larger your model, the more time you save—especially for prints with extensive infills.
• 【High-Speed Precision: Sharp Details Every Time】Say goodbye to under-extrusion, rough surfaces, and loss of detail. Unlike standard high-flow nozzles, Bamboo's high yet consistent extrusion ensures crisp edges, flawless texturing, and ultra-smooth surfaces—every single time.
• 【Quick Swap Nozzle Design】Very easy to install! *Please ensure that the hotend has cooled down before swapping, and avoid touching the heat block (lower section of the hotend) to prevent any risk of burns.
• Max. printing temperature 350 ℃. Upgrade now and print faster without compromise!
• 【Factory Pre-Tested Quality Assurance】To ensure zero clogs and perfect extrusion out of the box, every H2 Series hotend undergoes a strict factory calibration test using high-temperature test filament. You may notice a small amount of white or colored residue inside the nozzle tip. This is NOT a defect, grease, or used product. It is a sign of quality control. Simply heat the nozzle to your printing temperature and purge the filament; it will clear within the first few seconds of use, leaving you with a perfectly clean, high-performance hotend.